Thingiverse
3.5mm Audio Jack Reinforcement - Right Angle
by The_BeardBot
94
Downloads
93
Likes
0
Makes
3.5mm audio jack reinforcement with a 90 degree angle bend. May not fit all jacks, but it fit mine.
Th shells form a 4.4mm hole for the wires, and an 8.4mm hole for the jack. I printed it with supports to make a rough surface inside. I sanded the edges where the shells come together. I put hot glue in both shells, put the audio jack inside, put the two shells together, and as the glue dried I pushed the cable up into the casing. This gave the wires a bit of an arch and hopefully provided a li
Th shells form a 4.4mm hole for the wires, and an 8.4mm hole for the jack. I printed it with supports to make a rough surface inside. I sanded the edges where the shells come together. I put hot glue in both shells, put the audio jack inside, put the two shells together, and as the glue dried I pushed the cable up into the casing. This gave the wires a bit of an arch and hopefully provided a li
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in