Thingiverse
Raspberry Pi Pocket with PiCam mount for Tinkerine Ditto Pro
by gszczyrbak
1
Downloads
3
Likes
0
Makes
This bracket holds a CanaKit Raspberry Pi (without the lid) and attaches to the Tinkerine Ditto Pro. It has a place to mount a swivel PiCam mount as made by DanielBull.
The Pi pocket is a little tight and so is the part that hangs on the printer, but it fits. The PiCam doesn't swivel much on the Tinkerine due to my placement of the mounting hole.
The PiCam bracket is modified to accept a v2.1 PiCam. The chip pushes out a little to the right and didn't fit in Daniel's original design. It a
The Pi pocket is a little tight and so is the part that hangs on the printer, but it fits. The PiCam doesn't swivel much on the Tinkerine due to my placement of the mounting hole.
The PiCam bracket is modified to accept a v2.1 PiCam. The chip pushes out a little to the right and didn't fit in Daniel's original design. It a
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in