Thingiverse
Anet E12 Carriage Shroud
38
Downloads
41
Likes
0
Makes
This is yet another of my remixes. This one is for the Anet E10/E12. A couple key changes:
* Dropped the layer fan output by 4mm, so the air hits the bed, and not the thermistor
* Added some 45 degree edges to reduce the need for excess supports (and cleanup)
* Added top clips to the layer fan, so you only need the two original screws at the bottom
* Rounded out some of the holes to print better
* Added two angled ducts just above the heat block to keep the print from melting
* Removed
* Dropped the layer fan output by 4mm, so the air hits the bed, and not the thermistor
* Added some 45 degree edges to reduce the need for excess supports (and cleanup)
* Added top clips to the layer fan, so you only need the two original screws at the bottom
* Rounded out some of the holes to print better
* Added two angled ducts just above the heat block to keep the print from melting
* Removed
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in