12mm Vertical Shaft Support Block for OpenBeam

Hello
this is the 12mm Support block that will allow you to mount your shafts in upward position, its super sturdy, i printed one and it came out great, , just make sure that your print is in the upright position on the bed when printing

Spec:
Total Width 15mm( OPEN BEAM compatible)
Total length 50mm
Total Height is 40mm(the mounting base is 10mm and the top support potion is 30mm)
Shaft Supported by two M3(3mm) countersunk holes for nut and bolt.
The base secures to the OpenBeam