Thingiverse
Tronxy X3A Legs
by adre76
15
Downloads
5
Likes
0
Makes
I made these legs for a Tronxy X3A printer, but it will probably fit on others using a 2020 aluminum extrusion. They raise the printer by 100mm, allowing for a tronxy 3d printer's eletronics to fit underneath the printer.
Needed only a little sanding on my printer but your result may vary.
As always, blender was used for the entire design
Needed only a little sanding on my printer but your result may vary.
As always, blender was used for the entire design
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in