Thingiverse
Low Height TUSH for i3 and clones (Parametric)
by FeNi64
15
Downloads
4
Likes
0
Makes
This is a low-height TUSH-style spool holder for mounting on a Wanhao i3 or clone.
This is inspired by https://www.thingiverse.com/thing:2359860, but its height meant my enclosure didn't fit.
In the SCAD file you can adjust the bearing height and separation for your minimum spool size and clearance. The STLs are set up for 100mm separation to hold a 200mm spool. My 180mm spool just clears the holder. Smaller spools might scrape.
You will need four of 608zz bearings, and four 15mm M3
This is inspired by https://www.thingiverse.com/thing:2359860, but its height meant my enclosure didn't fit.
In the SCAD file you can adjust the bearing height and separation for your minimum spool size and clearance. The STLs are set up for 100mm separation to hold a 200mm spool. My 180mm spool just clears the holder. Smaller spools might scrape.
You will need four of 608zz bearings, and four 15mm M3
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in