Thingiverse
Lens cap for 52mm and 62mm.
by ohmykomu
12
Downloads
11
Likes
0
Makes
Made to hold both 52mm and 62mm lens caps. Created for a 40mm wide camera strap. Tested with a 52mm Nikon Lens cap and a Tamron 62mm lens cap. No sanding required - fits like a glove. Caps do not budge at all.
The design was made to be time and budget friendly - When printing at the print settings specified, it took 1 hour and 38 minutes to complete, and only used 13 grams of filament (4.37meter)
Only printed in PLA, but it's sturdy and seems to be standing up to most wear and tear.
The design was made to be time and budget friendly - When printing at the print settings specified, it took 1 hour and 38 minutes to complete, and only used 13 grams of filament (4.37meter)
Only printed in PLA, but it's sturdy and seems to be standing up to most wear and tear.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in