Thingiverse
Under-Printer Paper Shelf
by Vyrago
6
Downloads
8
Likes
1
Makes
Designed this to make my life a little easier.
Holds one ream of printer paper below the printer.
Supplies:
12 x quarter inch wooden (or metal if preferred) dowel rod. 14 inches long
2 x printed frame
You may have to drill out the holes, depending on how well your 3d printer is calibrated, or how accurate the dowel size is. I designed the holes for the dowels at 1/4 inch, but had to drill them at 17/64 to get them to fit the wooden dowel rods that were supposedly 1/4 inch.
Holds one ream of printer paper below the printer.
Supplies:
12 x quarter inch wooden (or metal if preferred) dowel rod. 14 inches long
2 x printed frame
You may have to drill out the holes, depending on how well your 3d printer is calibrated, or how accurate the dowel size is. I designed the holes for the dowels at 1/4 inch, but had to drill them at 17/64 to get them to fit the wooden dowel rods that were supposedly 1/4 inch.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in