Thingiverse
Heated chamber for Up! Plus/Afinia
16
Downloads
9
Likes
0
Makes
This is a heat chamber/enclosure for the up! plus/afinia printer.
It uses a small 200w hand heater such as [this one](http://www.dx.com/p/w-wy-01126-mini-200w-heater-w-stand-white-yellow-2-flat-pin-plug-220v-283881) and a thermostat like [this one](http://www.ebay.com/itm/24V-LCD-Digital-Temperature-Controller-Temp-with-Sensor-Thermostat-Control-Relay-/271275504553)
It can easily maintain 50°C inside the camber. Probably more if you wish.
It really helps with massive prints without warpi
It uses a small 200w hand heater such as [this one](http://www.dx.com/p/w-wy-01126-mini-200w-heater-w-stand-white-yellow-2-flat-pin-plug-220v-283881) and a thermostat like [this one](http://www.ebay.com/itm/24V-LCD-Digital-Temperature-Controller-Temp-with-Sensor-Thermostat-Control-Relay-/271275504553)
It can easily maintain 50°C inside the camber. Probably more if you wish.
It really helps with massive prints without warpi
Sign in to leave a comment
Sign in