Thingiverse
Pi 3B Case for Prusa MK3
by jmckeown2
363
Downloads
173
Likes
4
Makes
**NOTE:** This is for a Raspberry Pi Model 3/3+ [See HERE](https://www.thingiverse.com/thing:4525601) for the Pi 4 version.
I've seen many cases for mounting a Raspberry PI to the MK3 over the Einsy case. This mounts a Raspberry Pi 3B on the right side under the bed, which makes cable management a bit cleaner.
Print the bottom part and one of the tops depending on whether you need a slot for the camera's ribbon cable or not.
Also needed:
* 1x M4 T-nut for 30x30 extrusion
* 1x M4x10 cap
I've seen many cases for mounting a Raspberry PI to the MK3 over the Einsy case. This mounts a Raspberry Pi 3B on the right side under the bed, which makes cable management a bit cleaner.
Print the bottom part and one of the tops depending on whether you need a slot for the camera's ribbon cable or not.
Also needed:
* 1x M4 T-nut for 30x30 extrusion
* 1x M4x10 cap
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in