Thingiverse
Tronxy X5 - mainboard cover with reset and anti vibrating fan mount
19
Downloads
12
Likes
0
Makes
Simple cooling mainboard cover, with reset pin and anti vibrating mount for 40 mm fan, made for Tronxy X5.
(Goal: Cooling the IC very well - for long prints at high speeds and high bed temperatures. I printed ABS at 105C for more than 20 hours without having any heat problems on the mainboard. So there is no need for additional MOSFETs.)
You need 4 screws M3 x 40 mm and 4 nuts M3.
For mounting the 40 mm fan, two rubber bands are needed.
My settings: Wall = top = bottom = 1.2 mm
(Goal: Cooling the IC very well - for long prints at high speeds and high bed temperatures. I printed ABS at 105C for more than 20 hours without having any heat problems on the mainboard. So there is no need for additional MOSFETs.)
You need 4 screws M3 x 40 mm and 4 nuts M3.
For mounting the 40 mm fan, two rubber bands are needed.
My settings: Wall = top = bottom = 1.2 mm
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in