Thingiverse
Pooper Scooper 2
by jojowasher
30
Downloads
31
Likes
0
Makes
Designed a pooper scooper to go on the end of a broom handle, just wrap a poop bag over the end and tie it off, then when you are done pull it off and tie and toss! Printed it at .3 layer and 50% infill for strength but it could probably be printed at 30% just fine.
https://www.youtube.com/watch?v=cnyXT12SNBM
EDIT:
Updated this a bit to version 3, made it thinner, a bit shorter, and changed the angle of the front, also included a smaller version for smaller dogs, the larger one is good
https://www.youtube.com/watch?v=cnyXT12SNBM
EDIT:
Updated this a bit to version 3, made it thinner, a bit shorter, and changed the angle of the front, also included a smaller version for smaller dogs, the larger one is good
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in