Thingiverse

RADDS case for D-BOT

by printerboon

12 Downloads

6 Likes

0 Makes

Download Model

arduino arduino due case dbot enclosure RADDS arduino arduino due case dbot enclosure RADDS

I created an enclosure for my RADDS 1.5 board. It's _not_ snug fit, there is enough space to insert (and remove) the electronics without any force. Use four M3 screws and nuts to mount the electronics and two M5 screws to mount the enclosure to some 2020 profile.

Mount holes are located at the short side, so USB-connectors and SD-card slot will be face to the front.

The cover can hold two 40mm fans.

update: added a cover for a single 60mm fan. my (cheap) 40mm fans died, now I'm using

Source

Thingiverse

Comments

Makes