Thingiverse
Easily removable LACK enclosure wall bracket
by Lawec
49
Downloads
28
Likes
0
Makes
As I am currently building an IKEA LACK enclosure, I wanted a way to make sure it wouldn't topple over or vibrate too much when in use.
I designed this bracket with the design philosophy that it should be easy to pull the enclosure away from the wall without any special tools. All you need to replace is a cable tie holding the two parts together.
The slots are 3,5 mm in width.
I printed this in PLA, but materials such as nylon will probably be more suitable.
I will work on a way to get
I designed this bracket with the design philosophy that it should be easy to pull the enclosure away from the wall without any special tools. All you need to replace is a cable tie holding the two parts together.
The slots are 3,5 mm in width.
I printed this in PLA, but materials such as nylon will probably be more suitable.
I will work on a way to get
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in