Thingiverse
Yama Rc Buggy Servo Adaptor
by joelttyjoel
7
Downloads
1
Likes
0
Makes
I bought this used rc buggy and its servo was broken. Instead of buying a new and expencive servo I made a 3d printable adaptor which fits a "standard" servo.
The servo I use is the following: https://hobbyking.com/en_us/power-hd-lw-20mg-servo.html
To fit the print to the car i use standard wood screws that i screwed into the plastic of the print. This is holding up fine.
I think any other servo should fit but if it doesen't, feel free to remix this model and add a propper hole in the
The servo I use is the following: https://hobbyking.com/en_us/power-hd-lw-20mg-servo.html
To fit the print to the car i use standard wood screws that i screwed into the plastic of the print. This is holding up fine.
I think any other servo should fit but if it doesen't, feel free to remix this model and add a propper hole in the
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in