Thingiverse
PVC Spool Rack
by doguri
40
Downloads
26
Likes
0
Makes
Shelf that rests on the leg support of a Seville Classics UltraHD workbench.
Version 1: (Green in Photos)
Consists of two main supports, two 3/4 inch PVC pipe and 4 end caps.
The base slot on the support is 50mm wide and sits loosely on the leg support.
The pipe fittings are snug. Only the end caps were glued.
Version 2: (Blue in Photos.)
Supports are stackable.
The second beam is made from two printed brackets and two 1"x2" boards cut to 18 inches. The two boards are
Version 1: (Green in Photos)
Consists of two main supports, two 3/4 inch PVC pipe and 4 end caps.
The base slot on the support is 50mm wide and sits loosely on the leg support.
The pipe fittings are snug. Only the end caps were glued.
Version 2: (Blue in Photos.)
Supports are stackable.
The second beam is made from two printed brackets and two 1"x2" boards cut to 18 inches. The two boards are
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in