Thingiverse
2 Blade Wind propeller
by KhanKudo
6
Downloads
5
Likes
0
Makes
What you need to print :
1x p1
2x p2
2x p3 v1/v2
A screw is supposed to be put through the middle hole to spin it because plastic is too weak as shown with the previous 3 blade wind propeller. And I also used a drill to spin it but any motor does it.
difference between p3 v1 and p3 v2 is just the size. I couldn't print v1 becuse it was too big so I crated v2 which is smaller. You can choose either one of them but you need to print the same one ( You can't print 1x v1 and 1x v2 , you hav
1x p1
2x p2
2x p3 v1/v2
A screw is supposed to be put through the middle hole to spin it because plastic is too weak as shown with the previous 3 blade wind propeller. And I also used a drill to spin it but any motor does it.
difference between p3 v1 and p3 v2 is just the size. I couldn't print v1 becuse it was too big so I crated v2 which is smaller. You can choose either one of them but you need to print the same one ( You can't print 1x v1 and 1x v2 , you hav
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in