Thingiverse
Shower Knob Aperture Science Logo
5
Downloads
3
Likes
0
Makes
This is a replacement shower knob, I don't know if it will fit on your's but it is based off of the Aperture Science logo and a Moen single shower knob.
Printed @ 35% infill because my printer sucks. you might get away with less.
Ill include a DXF of the inner hole, I used that to print tests to see what would fit on my shower knob. (I recommend this, you want a tight fit, and this will use a lot less filament)
I had to try 3 times to get the tolerances right.
Also is included the
Printed @ 35% infill because my printer sucks. you might get away with less.
Ill include a DXF of the inner hole, I used that to print tests to see what would fit on my shower knob. (I recommend this, you want a tight fit, and this will use a lot less filament)
I had to try 3 times to get the tolerances right.
Also is included the
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in