Thingiverse
360° F-Duct MKII for JG Aurora A1/A3S/A5/A5S
by inventbox
157
Downloads
126
Likes
6
Makes
Here is the F-Duct MKII from the MKII Upgrade series which is available at http://www.inventbox.com
The JG F-Duct MKII also fits on the original radiator!
As material we recommend ABS or ASA. The layer height should be 0.15mm and the nozzle width or extrusion width 0.4mm. The cooling can be set to 10-20% to print the fine webs well. The printing speed should be about 40mm / s.
Support is only needed as shown in picture.
Further information at https://www.facebook.com/inventbox/
The JG F-Duct MKII also fits on the original radiator!
As material we recommend ABS or ASA. The layer height should be 0.15mm and the nozzle width or extrusion width 0.4mm. The cooling can be set to 10-20% to print the fine webs well. The printing speed should be about 40mm / s.
Support is only needed as shown in picture.
Further information at https://www.facebook.com/inventbox/
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in