Thingiverse
ZMR250-XT90 and Antennaholder combo
by Raines
3
Downloads
7
Likes
0
Makes
Inspired design by https://www.thingiverse.com/thing:1550668 but made to work with XT90.
What separates v2 and 3 from v1 is that the angle of the mount the xt90 is at a more upright angle.
What separate v3 from v1 and 2 is that the mounting holes are 1.5mm further from the back and also 3mm thick baseplate rather than 2mm.
Reason for the three versions is for testfiting.
v1 requires a straight edge of the carbonplate it mounts upon.
With v2 you get a tad more room and v3 just a little b
What separates v2 and 3 from v1 is that the angle of the mount the xt90 is at a more upright angle.
What separate v3 from v1 and 2 is that the mounting holes are 1.5mm further from the back and also 3mm thick baseplate rather than 2mm.
Reason for the three versions is for testfiting.
v1 requires a straight edge of the carbonplate it mounts upon.
With v2 you get a tad more room and v3 just a little b
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in