Thingiverse
Pagoda Stubby TPU case
by hulabaloo
5
Downloads
14
Likes
1
Makes
Since the original pagoda cover is open source, I chose the GNU license. Is this correct?
Anyhow, I took that cover and added a section for an SMA nut.
IF you build your own stubby it's best to start with a piece of wire 28-30mm long. Then expose about 3mm on each end for the center element. That length should fit this cover perfectly. I use the Andy Shen jig printed in PLA found here on thingiverse.
How to:
https://youtu.be/QOEE9oSiv8c
Printer: Prusa mk3
filament: Sainsmar
Anyhow, I took that cover and added a section for an SMA nut.
IF you build your own stubby it's best to start with a piece of wire 28-30mm long. Then expose about 3mm on each end for the center element. That length should fit this cover perfectly. I use the Andy Shen jig printed in PLA found here on thingiverse.
How to:
https://youtu.be/QOEE9oSiv8c
Printer: Prusa mk3
filament: Sainsmar
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in