Thingiverse
Dogfighter - MPX - firewall
by r_kopka
3
Downloads
1
Likes
0
Makes
This firewall is designed after the original part. The cooling holes are not quite precise but it will do.
The A part is 4mm thick with all the holes of the original.
The B part is 3mm thick without holes for the motor and a smaller central hole for use of a non standard motor. Both parts flex about the same. I don't recommend it for very strong motors, but the usual ones should be OK. I didn't test the parts in flight, yet. For more strength just print it thicker.
I intend to do a version
The A part is 4mm thick with all the holes of the original.
The B part is 3mm thick without holes for the motor and a smaller central hole for use of a non standard motor. Both parts flex about the same. I don't recommend it for very strong motors, but the usual ones should be OK. I didn't test the parts in flight, yet. For more strength just print it thicker.
I intend to do a version
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in