Back
3DSEARCH / 40mm Fan mount for reinforced prusa X carriage
40mm Fan mount for reinforced prusa X carriage – 3D printable model from Thingiverse Thingiverse

40mm Fan mount for reinforced prusa X carriage

by profezzorn
26 Downloads
74 Likes
1 Makes
Download Model
holder mendel model mount reprap
It's has a small shroud, it fits even if you use a 36mm hot-end, it allows you to adjust the angle of the air flow.
Source
Thingiverse
Comments
0

Comments

No comments yet – be the first!
All Thingiverse Models More by profezzorn

Similar Models

6 Suggestions
Fan duct for prusa mendel V2 model Heacent 3DP02 (K-extruder)
Fan duct for prusa mendel V2 model Heacent 3DP02 (K-extruder)
by pierrelesek
↓ 5 ♥ 2
Pen Holder for Prusa Mendel
Pen Holder for Prusa Mendel
by triffid_hunter
↓ 60 ♥ 59
Top spool holder fore reprappro mendel
Top spool holder fore reprappro mendel
by levmov
↓ 1
side spool holder for prusa mendel i2
side spool holder for prusa mendel i2
↓ 3 ♥ 6
YAFSH Spool Holder 30mm diameter
YAFSH Spool Holder 30mm diameter
by SecondOne
↓ 3 ♥ 2
Prusa endstop holder with taller clamp for less play
Prusa endstop holder with taller clamp for less play
by triffid_hunter
↓ 47 ♥ 47

Add to Collection