2d Printing Adapter

This is an adapter for holding various pens or markers to enable your printer to write and draw. Use 0 or 1% extrusion, 0 nozzle and 0 bed temp, and enable z-hop and set it to 2mm. You can make a .2mm lithophane and use 1 wall with 0 infill. Attach this where the cooling fan would usually go, then tape a piece of paper down. Take care to ensure the writing utensil will not hit any part of the printer when in operation. Level you bed to make the utensil just touch the surface. Adjust the z-offset while printing. Happy p̶r̶i̶n̶t̶i̶n̶g̶ drawing!