Thingiverse
2S Balance Connector Cap
door bartholomule
0
Downloads
0
Likes
1
Makes
A simple cut of the 3s JST-XH connector to fit a 2s.
Printed in Ninjaflex. It's tight. Non-flexible filaments will probably not fit.
Took some measurements of the 2s and 3s connectors, and cut 2.5mm from the middle of 3dnob's 3S cap. Cut with Prusaslicer.
At 100% size, this is tight when printed in flexible. At 101%, it fits nicely, but is still not too difficult to remove from the balance connector.
Printed in Ninjaflex. It's tight. Non-flexible filaments will probably not fit.
Took some measurements of the 2s and 3s connectors, and cut 2.5mm from the middle of 3dnob's 3S cap. Cut with Prusaslicer.
At 100% size, this is tight when printed in flexible. At 101%, it fits nicely, but is still not too difficult to remove from the balance connector.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!