Slicer Discord
2S Lipo Battery Case – 3D printable model from MakerWorld MakerWorld
RC

2S Lipo Battery Case

by paraic · RC
82 Downloads
22 Likes
43 Makes
Go to Model
A case for 2S whoop batteries, E.g. 450mAh, 550mAh 2S batteries. Tested with Lava brand, but should be good for others too. This case holds 9 2S batteries. They fit snugly and don't rattle about. There is plenty of room at the top for all of the leads.I'm really happy how this came out. It's great for throwing in your FPV gear bag. Obviously this is not fire proof so please store your batteries safely. This case is only for convenience going to the field. ***Important!! Please read the following. The lid for this case is interference fit. This means that if you press it fully on first try, it may stick in place and you will have difficulty releasing it. I recommend using a table knife as a spacer to prevent this. Place the lid on with a blunt knife edge at the rim and take it off SEVERAL times before pressing it on fully. This will loosen it enough to function correctly. I did design a lid with less friction, however that one became to loose with use. This one stays in plac
Category
RC
Source
MakerWorld
Published
Updated
What you need to print this: Beginner Low confidence
Single piece
Supports 1/3
Assembly 0/3
Settings 1/3
Bed size 0/3
Post-process 0/3
Printer
FDM / FFF
File format
STL
Material
PLA
Software
Cura, PrusaSlicer, or similar
No ratings yet
No comments yet – be the first!

Similar Models

6 Suggestions
Feed Blog Slicer Cost Calculator Image Search Submit Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Add to Collection