Slicer Discord
2U MATX rack mount – 3D printable model from MakerWorld MakerWorld
Electronics

2U MATX rack mount

82 Downloads
46 Likes
12 Makes
Go to Model
WARNING, THIS DOES NOT FIT ALL MATX BOARDS, DOUBLE CHECK BEFORE YOU PRINT! This is a 2U 19 inch rack mount designed to fit a m-atx board and a standard atx psu (140mm length). There is room for 3 40mm fans and a 2.5" drive, you might be able to fit even more in there if you use a modular psu. Important notes This model should be printed with a filament that has a higher heat resistance (ABS or ASA) If you are printing on a medium size build plate (p1s, p2s, x1c, etc) make sure to use bed clamps or a thicker build plate and keep the chamber temp high to prevent warping (the model in the picture warped while still stuck to the build plate which caused the plate to lift off the bed). Also make sure the build plate is extra clean because the two slices of the case take up the majority of the build plate When mounting this in a cabinet make sure there is room for the power supply to properly intake/exhaust air If printing on a larger build plate (h series printers, etc) you should slice the
Category
Electronics
Source
MakerWorld
Published
Updated
What you need to print this: Advanced Low confidence
Supports 1/3
Assembly 2/3
Settings 1/3
Bed size 0/3
Post-process 1/3
Printer
FDM / FFF
File format
STL
Material
PLA, ABS, Polycarbonate
Post-processing
Gluing
Software
Cura, PrusaSlicer, or similar
Same designer, more platforms

JKA STUDIOS also publishes on

2 additional models across 1 more platforms

Verified by matching model titles across platforms.
No ratings yet
No comments yet – be the first!

Similar Models

6 Suggestions
Feed Blog Slicer Cost Calculator Image Search Submit Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Add to Collection