Thingiverse
2x4x5
von kequals
40
Downloads
34
Likes
0
Makes
A 2x4x5 twisty puzzle. This puzzle can shapeshift.
To make the puzzle, print each piece by the number indicated on the filename:
* 4 Top Corner
* 4 Bottom Corner
* 4 Left Wing Edge Side 4
* 4 Right Wing Edge Side 4
* 4 Left Wing Edge Side 5
* 4 Right Wing Edge Side 5
* 4 Edge
* 4 Left Corner Center
* 4 Right Corner Center
* 1 Edge Center 1
* 1 Edge Center 2
* 2 Edge Center 3
* 1 Pin
To stop it from breaking, print Pin with 100% infill.
You need 1 extremely tiny M3 screw. I took a screw and ground it down until it was about 6mm long but still had some threads left.
Stickers can be cut from the attached template.
To make the puzzle, print each piece by the number indicated on the filename:
* 4 Top Corner
* 4 Bottom Corner
* 4 Left Wing Edge Side 4
* 4 Right Wing Edge Side 4
* 4 Left Wing Edge Side 5
* 4 Right Wing Edge Side 5
* 4 Edge
* 4 Left Corner Center
* 4 Right Corner Center
* 1 Edge Center 1
* 1 Edge Center 2
* 2 Edge Center 3
* 1 Pin
To stop it from breaking, print Pin with 100% infill.
You need 1 extremely tiny M3 screw. I took a screw and ground it down until it was about 6mm long but still had some threads left.
Stickers can be cut from the attached template.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!