Thingiverse
3/4x10 Thread Protector - Mac11 - Airsoft
di HardlyLethal
10
Download
13
Likes
0
Makes
Just a simple knurled thread protector for the Mac-11's weird 3/4-10 threaded barrel. Only tested on a VMac9. Should work on other Mac-11s assuming the distance from the end of the barrel to base of the barrel is about 39mm.
Uploaded a v2 after shooting off the tip within the first shot. The original covered the end with a hole as big as the bore. The v2 sits even with the end of the barrel (tapered section extends a bit past though). Print this one if you plan to actual shoot with it on.
Uploaded a v2 after shooting off the tip within the first shot. The original covered the end with a hole as big as the bore. The v2 sits even with the end of the barrel (tapered section extends a bit past though). Print this one if you plan to actual shoot with it on.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!