Thingiverse
Electronics
Zum Modell
3.5 HDD STORAGE BOX
121
Downloads
85
Likes
0
Makes
I wanted somewhere to keep all the extra bits and pieces that come with building a computer. I also wanted them to stay with the computer. Then I realized I would have a couple 3.5" HDD slots open so when I couldn't find a good 3.5" HDD storage box I decided to make my own.
No supports needed.
After you print both pieces, the hinge is sized so you can slide a 1.75 filament through to finish it off. I will also melt and flatten the ends to keep the filament from sliding out.
Let me know if it works for you.
No supports needed.
After you print both pieces, the hinge is sized so you can slide a 1.75 filament through to finish it off. I will also melt and flatten the ends to keep the filament from sliding out.
Let me know if it works for you.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
