Thingiverse
3.5 inch plus quadcopter frame
von borjos
0
Downloads
0
Likes
0
Makes
printed with creality hyper ABS. I seriously recommend this, for an easy, sturdy print.
print frame with brim.
print pod with supports and brim.
print frame as is, pod rotated 90 to be "on it's side"
hand ream small holes with 2mm drill, large ones with 4mm drill
use 8mm M2 screws for the motors
built in photo with GepRC taker g4 35A AIO + T-Motor P1604 3600KV + runcam link/wasp
print frame with brim.
print pod with supports and brim.
print frame as is, pod rotated 90 to be "on it's side"
hand ream small holes with 2mm drill, large ones with 4mm drill
use 8mm M2 screws for the motors
built in photo with GepRC taker g4 35A AIO + T-Motor P1604 3600KV + runcam link/wasp
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!