Thingiverse
3.5” SD Card Reader Case
von jbeardslee
1
Downloads
2
Likes
0
Makes
3.5” SD Card Reader Case
This is a Case to hold a popular 3.5” Card Reader. Many new PC Cases do not have any 3.5” bays. This Case allows the SD Card Reader to be used Externally. The cable must still go inside the PC to plug into a USB header on the Motherboard. After printing, drill out the screw holes with an 1/8” drill bit.
I printed it with the back down on the plate, standing up. I used a Brim to help plate adhesion and used no Support.
This is a Case to hold a popular 3.5” Card Reader. Many new PC Cases do not have any 3.5” bays. This Case allows the SD Card Reader to be used Externally. The cable must still go inside the PC to plug into a USB header on the Motherboard. After printing, drill out the screw holes with an 1/8” drill bit.
I printed it with the back down on the plate, standing up. I used a Brim to help plate adhesion and used no Support.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!