Thingiverse
3.5mm mono jack and array
8
Downloads
9
Likes
0
Makes
Hello!
This is a simple audio jack for 3.5mm mono plugs. The contacs are made of paperclips.
The jack comes in a single version and in an one-piece 9-jack-array, so to say.
It is recommended to use PETG as printing material, as PLA tends to loose its elasticity.
Just print, take two pieces of paper clip wire (0.8 to 1.0mm diameter), bend the wires as shown and assemble.
Scale a bit if the jack s too tight or too loose.
Please feel free to use the ipt-file for your own designs.
Have fun!
This is a simple audio jack for 3.5mm mono plugs. The contacs are made of paperclips.
The jack comes in a single version and in an one-piece 9-jack-array, so to say.
It is recommended to use PETG as printing material, as PLA tends to loose its elasticity.
Just print, take two pieces of paper clip wire (0.8 to 1.0mm diameter), bend the wires as shown and assemble.
Scale a bit if the jack s too tight or too loose.
Please feel free to use the ipt-file for your own designs.
Have fun!
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
