3 Cubes Flower Planter

I have not printed this one yet. I am waiting on more wood PLA and a hardened nozzle. This is similar to the hexagon planter I designed previously, but with squares. I moved the corner lugs/feet from the planter to the tray on this one so that there would be considerably less support needed.

The tray sits nicely underneath it with the raised corners acting like locking lugs to hold the tray cleanly underneath the planter if it is pushed or slid around.

If I were to print it, it would be with a Prusa i3 MkII at 0.20mm with supports only for the planter because of the corner overhangs. I like to use 20% cubic infill, but you can use whatever you want. Just remember, there is a bit of a span and the wet soil weighs more than you think, so don't get too thin on the infill and perimeters.

I would print it at 4 layers top and bottom, and 2 perimeters minimum.