3-extruder base with LCD controller stand
par printingSome
12
Téléchargements
11
Likes
0
Makes
This design feels very bendy, because of the thin base, but the 8mm acryl edge it sits on, makes it sufficiently sturdy.
The long legs serve to bridge the hole onderneath, which again is very handy to guide the teflon tubes through.
In the first print of the design I made the holes for the fittings a bit small, so the thread in them is at risk.
As you can see in the pictures it went wrong with the middle one, but it was easy to make the hole a bit greater.
I have adapted the design, so the fittings get straight on to the extruder-house.
The LCD controller-box is from http://www.thingiverse.com/thing:1116163, with thanks.
The long legs serve to bridge the hole onderneath, which again is very handy to guide the teflon tubes through.
In the first print of the design I made the holes for the fittings a bit small, so the thread in them is at risk.
As you can see in the pictures it went wrong with the middle one, but it was easy to make the hole a bit greater.
I have adapted the design, so the fittings get straight on to the extruder-house.
The LCD controller-box is from http://www.thingiverse.com/thing:1116163, with thanks.
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !