3 Inch Flow Frame Quad

This is an (approximately) 100mm quad frame that takes 3" props and 11XX series brushless motors. I designed it for Emax RS1106 motors but most 11xx series motors should fit. The mounting holes are 20mm x 20mm and will fit most small FC / 4in1 ESCs.

The plastic parts for the frame weigh about 17g total when printed with Esun ABS

You will need the following hardware for the frame:

- 4x M2x6mm bolts to hold the side panels onto the frame.
- 5x M2x30mm bolts to go between the frames
- 4x M2x20mm bolts to secure the Flight Controller stack.

I will continue working on this and updating this thing as I make changes / improvements.