3 Part Angular Bauble Mould for Slipcasting

Fully printed system to make plaster moulds. This produces a 3-part mould to cast round ornaments with an angular design. This print has been scaled to 112% to account for clay shrinkage, which should give a final ornament size of 6.5cm diameter with most casting slips. If you want it smaller/larger than 6.5cm, scale every piece of the print. With any fully 3D printed mould, you’ll benefit from using a release agent on the base plate surface. I use a generic mouldmaker’s soap, but any product designed for plaster release should be fine.It needs around 375ml of plaster, and you can calculate the weight of water and plaster needed with this tool: Plaster CalculatorYou can get a much better cast surface, even if your plaster mix is full of air bubbles, by using a paintbrush to dislodge any trapped air from the surface. I would suggest that you pour plaster until the ornament surface is covered but it isn’t completely full, then get a relatively small paintbrush and move it around in the p