3" Tape Core

Scotch 3" Tape Core V2 This is designed to the same dimensions as my original, but uses 10% less filament. I was inspired to create a three lobe design to give an additional choice to the full surface cylinder original design. The spindle is sized for a 2" roll and 2 printed core inserts. You will need to resize the length for the 1" wide dispensers. Version 1 versus the Fully Redesigned Version 2You can find my Original Design here:https://makerworld.com/en/models/1510709-scotch-c22-tape-dispenser-core#profileId-1581663 Boost MePlease Consider Boosting if you find these useful and happen to have any hanging around that are getting set to expire. A little boost goes a long way. Thank You for your Interest, Downloads and Prints!