Thingiverse
RMRC Recruit V2 FRSky L9R Holder
by Jero1987
11
Downloads
8
Likes
0
Makes
This will hold your FRSky L9R Antenna on your Recruit v2. It is much better for reception if you can have at least one antenna vertical.
It has holes for mini zip ties. I would HIGHLY recommend also using double sided mounting tape.
You can probably print this with PLA, however, I used TPU and it gives the mount a bit of flex.
Print on the bottom with supports.
NOTE: By default the mount will print for the left side of your drone. If you are using the original VTX mount by QuadView t
It has holes for mini zip ties. I would HIGHLY recommend also using double sided mounting tape.
You can probably print this with PLA, however, I used TPU and it gives the mount a bit of flex.
Print on the bottom with supports.
NOTE: By default the mount will print for the left side of your drone. If you are using the original VTX mount by QuadView t
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in