Thingiverse
Flower Test Carve
door mstrperson
15
Downloads
15
Likes
0
Makes
Little test piece I drew up to test out my new X-Carve. Came out really good.
Designed in Fusion360, used MeshCAM for producing the gcode files.
The Roughing pass uses a 1/4" Endmill.
Finishing and Waterline passes both use a 1/8" Ballnose.
The programmed feedrate in the gcode is 100in/min for roughing and 50in/min finishing, but using the feedrate override in Easel I ran at 160in/min roughing and 100in/min finishing with no problems using my Dewalt 611 router since I was carving in j
Designed in Fusion360, used MeshCAM for producing the gcode files.
The Roughing pass uses a 1/4" Endmill.
Finishing and Waterline passes both use a 1/8" Ballnose.
The programmed feedrate in the gcode is 100in/min for roughing and 50in/min finishing, but using the feedrate override in Easel I ran at 160in/min roughing and 100in/min finishing with no problems using my Dewalt 611 router since I was carving in j
Makes
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
Inloggen