Hyperlite FlosStyle Battery Pad

Print in rubber PLA or similar with 10-15% infill and 2 walls and top/bottom layers so that it has some flex.

This isn't designed to be held down by the top plate screws. I just used thin double sided tape to mount it.

May work in TPU but the TPU I have is a little hard. May work with 2 straps but I'm too lazy to use more than one.

NOTE: This will never be as good as the 3M pads. I use battery straps that have a similar rubber to the 3M pads on them so they help to stop the battery from