Thingiverse
Angled MK3 Heatbed Cover with Nylon Filament Hole
by zcubed
49
Downloads
16
Likes
1
Makes
I made a few small amendments to the already great design by MIKEYMCC for my MK3.
- Added a support hole for the 3mm Nylon Filament included with my kit to keep the wires in shape
- Reduced the top piece height by a little more than 1mm to make it more low profile
- Moved the Nut pockets to the bottom half so its easier to install and remove
NOTE: This only works for the original MK3 SOLDERED bed terminals. The screw terminals on the newer beds will not fit.
- Added a support hole for the 3mm Nylon Filament included with my kit to keep the wires in shape
- Reduced the top piece height by a little more than 1mm to make it more low profile
- Moved the Nut pockets to the bottom half so its easier to install and remove
NOTE: This only works for the original MK3 SOLDERED bed terminals. The screw terminals on the newer beds will not fit.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in