4mm OD bowden tube beveling jig for use with single edge razors.

this is similar to the parent thing, but is made for a single edge razor to be installed untill it needs to be changed.

you will need the follwoing
1x m2 6mm long countersunk screw
1x m2 nut
1 single edge razor blade

to build
1. set one on the side slots on the blade in the pin (its inside the blade chanel, near the tip) and use as a hinge to seat the blade.
2. move the blade around to get the center hole aligned with screw hole.
3. hold the m2 nut in place and screw the m2 counter