Thingiverse
Fabrikator Mini 1.5 Multi-Fan base
by sinned6915
5
Downloads
5
Likes
0
Makes
Multi-Fan base for Turnigy Fabrikator Mini 1.5 to raise the entire printer up and provide for more airflow to the controller board.
Designed to screw the fans from the TOP with M4 screws. Screws should form their own threads into the holes. There is a 2mm lip at each corner for fan to key into to. you may have to finesse these edges a little bit for your fan.
Fan sizes from 50mm, 60mm, 70mm, 80mm, 90mm and 120mm, so you can use any recycled PC case fan. No sense in spending $25 on a new
Designed to screw the fans from the TOP with M4 screws. Screws should form their own threads into the holes. There is a 2mm lip at each corner for fan to key into to. you may have to finesse these edges a little bit for your fan.
Fan sizes from 50mm, 60mm, 70mm, 80mm, 90mm and 120mm, so you can use any recycled PC case fan. No sense in spending $25 on a new
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in