Thingiverse
Chibi Monika model (DDLC)
by marcosrb
40
Downloads
62
Likes
2
Makes
Chibi Monika model.
This is a model based from the Chibi Monika from Doki Doki Literature Club. It's a 2,5 dimensions .stl archive to be printed in a 3D printer without any post-treatment.
The picture shows the original .stl printed with PLA with 5% hexagonal fill with 2 walls with perimeter. It has about 10,5 cm x 7,5cm x 0,5 cm of size.
Please note that, as the neck is too thin, it can break easily. Seriously, it wasn't intended to be like that, Natsuki lovers.
Check https://ddlc.m
This is a model based from the Chibi Monika from Doki Doki Literature Club. It's a 2,5 dimensions .stl archive to be printed in a 3D printer without any post-treatment.
The picture shows the original .stl printed with PLA with 5% hexagonal fill with 2 walls with perimeter. It has about 10,5 cm x 7,5cm x 0,5 cm of size.
Please note that, as the neck is too thin, it can break easily. Seriously, it wasn't intended to be like that, Natsuki lovers.
Check https://ddlc.m
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in