Thingiverse
Kindle Paperwhite 2/3 Case
by TurboGLH
3
Downloads
2
Likes
0
Makes
v2 has fixed radius on the pocket, older version had a mistake that caused some slight warping when fully seated.
STEP Files Included
Full back Kindle Paperwhite 2/3 Case I made for my wifes project. None of the existing ones had model files, and it was also difficult to remove the kindle from the case without significant force/twisting.
Has three retaining points vs four, and large radiuses on either side of the top one, allowing for easy removal.
Supports are needed for the two low
STEP Files Included
Full back Kindle Paperwhite 2/3 Case I made for my wifes project. None of the existing ones had model files, and it was also difficult to remove the kindle from the case without significant force/twisting.
Has three retaining points vs four, and large radiuses on either side of the top one, allowing for easy removal.
Supports are needed for the two low
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in