Thingiverse
Creality Ender 3 Full LCD CaseCover
by RickoH24
336
Downloads
214
Likes
2
Makes
Just a remix for my Ender 3 LCD electronics & LCD.
Hope you like it!
It uses the original stock screws and the flippy cover can be attached with a simple bread wire.
To install it, you have to dismount entirely the electronics board from the stock vessel, (pull the rod out gently), slide it in carefuly and bend a little the 3dprint cover vessel. Then just fit the electronic board in place, reattach to the metal LCD stand, screw in and you're DONE!
Used these incredible and clever d
Hope you like it!
It uses the original stock screws and the flippy cover can be attached with a simple bread wire.
To install it, you have to dismount entirely the electronics board from the stock vessel, (pull the rod out gently), slide it in carefuly and bend a little the 3dprint cover vessel. Then just fit the electronic board in place, reattach to the metal LCD stand, screw in and you're DONE!
Used these incredible and clever d
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in