Thingiverse
Cateye TL-LD1100 rear light mounting bracket
by db2000
4
Downloads
2
Likes
0
Makes
mounting bracket for Cateye TL-LD1100 rear light.
Printed out in PLA 40% infill and 3 shells. The bracket is quite large to make sure its strong so these settings wouldn't be all that critical.
Use a soldering iron to push in the nuts, M3 nuts for the slide on bracket and 10mm long screws. M4 nuts and 16mm long screws to hold the bracket to the rack. Some loctite on the threads to stop things shaking loose.
You might need to sand the slide bracket a little to get it to slide on. The
Printed out in PLA 40% infill and 3 shells. The bracket is quite large to make sure its strong so these settings wouldn't be all that critical.
Use a soldering iron to push in the nuts, M3 nuts for the slide on bracket and 10mm long screws. M4 nuts and 16mm long screws to hold the bracket to the rack. Some loctite on the threads to stop things shaking loose.
You might need to sand the slide bracket a little to get it to slide on. The
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in