Thingiverse
1x2x4
by kequals
41
Downloads
39
Likes
0
Makes
A 1x2x4 twisty puzzle. Every layer can turn in increments of 180 degrees. This puzzle cannot shapeshift.
To make, print each part by the number indicated on the filename:
* 1 Alignment
* 1 Pin
* 3 Short
* 4 Long
The screw I used was M3 x 5mm. I first found a small M3 screw, then manually ground it down until it was 5mm long. Make sure that your screw is still threaded. The screw needs to be extremely small for the puzzle to work.
Stickers are standard 57mm 3x3.
To make, print each part by the number indicated on the filename:
* 1 Alignment
* 1 Pin
* 3 Short
* 4 Long
The screw I used was M3 x 5mm. I first found a small M3 screw, then manually ground it down until it was 5mm long. Make sure that your screw is still threaded. The screw needs to be extremely small for the puzzle to work.
Stickers are standard 57mm 3x3.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in