Thingiverse
USB Camera Mount for Prusa MK3
by Nate456789
32
Downloads
8
Likes
0
Makes
Use this to mount your USB camera to your printer frame. I am using it for a Logitec 920.
The mount has 2 pieces and relies on the m3 blind nut backing piece to tighten down on the frame.
I used an M3 16mm bolt.
You will only need supports on the T backing piece. I chose to print this piece with the backing nut portion facing up. No other items needed support.
When assembling, set the blind nut using the bolt - Don't over tighten - then remove the bolt and push the backing T piece into the
The mount has 2 pieces and relies on the m3 blind nut backing piece to tighten down on the frame.
I used an M3 16mm bolt.
You will only need supports on the T backing piece. I chose to print this piece with the backing nut portion facing up. No other items needed support.
When assembling, set the blind nut using the bolt - Don't over tighten - then remove the bolt and push the backing T piece into the
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in